Detail & Specs
This configuration is not available. Make another selection.
Metric Step-Down Stud / Double Ended
These studs step down from 8mm diameter threading on one side to 6mm threading on the other side.
Double ended studs, or "tap end studs" have a shorter length of thread on one side, an unthreaded middle shank, and a longer length of thread at the other end. Both sides are right hand threaded and can accept a nut or installation into a tapped hole.
Lengths shown are overall.
Material
Class 8.8 metric studs provide a medium strength, high tensile fastening solution. Pair with Class 8 or stronger nuts.
Also known as threaded pin, tap end stud bolt, setup stud, externally machine threaded headless fastener
Watch our video about the stud installation tool here.
