Detail & Specs
This configuration is not available. Make another selection.
M10 - Even Thread / Double End Coarse Stud Class 10.9 Hardened
M10X1.5, M10X1.50, M10
Even studs, or "tap end studs" have the same length of thread at either end with an unthreaded shank in the middle. Both sides are right hand threaded and can accept a nut or installation into a tapped hole.
Diameter: 10mm
Pitch: 1.5 Coarse Thread
Material: Class 10.9 Hardened Steel
Also known as threaded pin, externally threaded headless fastener
