Detail & Specs
This configuration is not available. Make another selection.
M10X1.5 Cone Point Set Screw - DIN 914 Zinc Plated
Cone point set screws have a pointed taper meant to pierce flat surfaces or fit into pre-drilled holes in a mating surface to create a secure connection. Commonly used in industrial assembly automation components to increase efficiency.
Also known as a pointed grub screw.
Measured by overall length, an allen socket hex drive is used to tighten this set screw.
For use in compression only, not for tensile or shear loads.
Set screws can be used as an easy-to-install alternative to full thread studs because they have an internal allen socket drive at one end.
Material 45H Steel
Zinc Plated finishes provide corrosion resistance without sacrificing strength.
Alternate Specification DIN 914 / ISO 4027
Special Order Product Policy
- Special Order Parts are Available ONLY in Box Quantities
- Special Order Parts are Not Returnable & Cannot be cancelled after order confirmation
- Free Domestic Shipping over $99 will be offered in your special order quote if applicable.
- For a full list of Special Order Policies: Please Click Here
