As of May 1, 2021 our website no longer supports Internet Explorer 11.

We recommend that you update your browser here.

Microsoft Edge | Firefox | Chrome

Free Domestic Shipping at $49.99

M2.5 Grooved Pin PARTIAL Length Parallel

A1 / AISI 303 Stainless

DIN 1474

SKU: 00-Y1474-A1-M2.5
Minimum Box: Select a valid option

This configuration is not available. Make another selection.

Detail & Specs

This configuration is not available. Make another selection.

M2.5 Grooved Pins PARTIAL Length Reverse Taper - 303 Stainless DIN 1474

Press fit pin with three half-length reverse taper grooves.

Grooved pins are actually 'fluted', material is displaced in a swaging operation. Their holding power comes from the swaged material compressing into the hole. Also known as solid press-fit fasteners, used in pivots, levers, or locking fasteners.

Reverse grooves gradually increase in size from the end along a section of the shaft, creating a progressively larger diameter.

Used for integrity of screw joints by providing alignment and support while also managing the forces that can act on the joint during operation.

How to Measure:

To measure a press fit pin, measure the length of the pin (including the chamfers if present) and the diameter of the smaller end.

Material: A1 / SAE Type 303

A1 / 303 Stainless pins are commonly used in machining, the automotive industry, as well as for decorative strips, door handles and oil drain valves.

For any application involving marine (salt water), use A4 / 316 Stainless Steel material.

Special Order Product Policy

  • Special Order Parts are Available ONLY in Box Quantities
  • Special Order Parts are Not Returnable & Cannot be cancelled after order confirmation
  • Free Domestic Shipping over $99 will be offered in your special order quote if applicable.
  • For a full list of Special Order Policies: Please Click Here